Xerox DocuColor a2 Manual do Utilizador descarregar pdf (Página 73)

DOCUCOLOR 12 SYSTEM ADMINISTRATION GUIDE 3–37 TOOLS MODE

Perform one of the following:

• Use the up and down arrows (Figure 55) to

increase or decrease the desired time before

returning to the default settings after a job is

complete or only partially programmed,

entering Low Power mode, powering off, or

exiting System Administration mode. Be sure

to stay within the stated minimum and

maximum times.

• Touch the Timeout Disabled button to

prevent the machine from timing out.

NOTE: The disable option is not available on

the Low Power Timeout or Auto Power Off

screen. If the copier/printer is not used for

over four hours (default setting), it must enter

Low Power mode.

To re-enable an option that was previously

disabled, use the up arrow to set a new time.

Touch Close to display the Timeouts screen.

If necessary, repeat steps 2 through 4 for other

timeout settings.

Touch Close to display the Tools screen.

Figure 55: Sample timeout setting screen

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 111 112

Sem comentários

Xerox DocuColor a2 Manual do Utilizador Página 73